Complete ignition with VEC coil and 6 volt light coil for clockwise rotating automatic engines such as those installed on Puch Maxi S, N mopeds / mopeds with E50 engines.
The set includes all parts such as fastening screws, flywheel nut with wedge, ignition plate, ignition and light coil, pole wheel and spark plug connector.
The components are supplied individually and still need to be assembled.
Direction of rotation: Right (clockwise)
Operating voltage of the light system: 6 volts
Wattage of the light system: 17 watts
Ø inside flywheel: 90 mm
Attention: A spark plug connector with at least 10 kOhm discharge must be used, the spark plug must not be discharged!
With Beru or MERIT spark plug connectors, misfiring may occur.
Adjusting the ignition:
In principle, nothing needs to be adjusted on the ignition. Only the ignition plate can be turned slightly for a perfect ignition spark, the rest is regulated by the ignition chip.
In the basic setting, the three fastening screws of the ignition plate are located in the middle of the slotted holes. Pre-tensioning is achieved by turning the ignition plate against the direction of motor rotation. Fine adjustment is carried out at medium speed using the strobe light. The electrode gap on the spark plug must be set to 0.7 - 0.8 mm in advance.
The ignition timing adjustment gun as well as other tools and individual parts for your ignition can be found in the accessories section.
The set includes the following fixed parts:
Manufacturer: GPO · Pony spare part no.: A2133, A5532 · Sachs spare part no.: 0265 140 005, 0265 206 000
Manufacturer: GPO · Material: Steel, Plastic · Tension: 6 V · Performance: 17 W · Direction of rotation: right · Ø cone small inside: 11.5 mm · Ø cone large inside: 15 mm · Cone length: 18.5 mm · Cone ratio: 1:5 · Ø Internal flywheel: 91.1 mm · Ø Flywheel outside: 116.5 mm · Thread type: MF26x1.5 (fine pitch thread) · Thread length: 7 mm · Weight: 900 g · Height: 36.5 mm
Manufacturer: NGK · Material: Plastic, Rubber · Color: black · Ø cable: 5 mm, 7 mm · Spark plug socket: SAE · Cable available: No · Suppressed: Yes · Resistance: 10000 Ω
Manufacturer: GPO · Material: Steel · Surface: blue galvanized · Area of application: Standard · Nut type: Flange nut · Drive: External hexagon · Thread type: MF10x1 (fine pitch thread) · Ø outside: 18.8 mm · Height: 8.9 mm · Width across flats SW: 14 mm · Pony spare part no.: A4513 · Sachs spare part no.: 0942 072 102
Material: Steel · Total length: 9.15 mm · Width: 3 mm · Height: 3.7 mm
Manufacturer: swiing® revival parts · Material: Steel · Surface: blue galvanized · Alternative version of the Puch spare part no.: 900.3202, 900.1509
Tension: 6 V · Performance: 17 W · Ø Internal flywheel: 90 mm · Height: 25.2 mm · Total length: 76.8 mm · Mounting type: Screws · Number of fixing points: 2 pcs · Ø mounting hole: 4.1 mm · Hole spacing: 54 mm · Area of application: Standard, Original
Manufacturer: VEC · Place of use: Internal (in the ignition) · Ø Internal flywheel: 90 mm · Ø cable holder: 5 mm · Cable length: 140 mm, 420 mm · Color: black · Total length: 77 mm · Height: 48 mm · Mounting type: Screws · Number of fixing points: 2 pcs · Ø mounting hole: 4.6 mm · Hole spacing: 54 mm · Area of application: Standard, Original, Performance
Details
| Manufacturer | VEC, GPO |
| Area of application | Tuning, Standard |
| Tension | 6 V |
| Performance | 17 W |
| Direction of rotation | right |
| Ø cable | 5 mm |
| Mounting type | Screws |
| Ø Internal flywheel | 90 mm |
Suitable for the following models
| Puch | E50 |
Accessories & related products
GPO flywheel trigger M26x1.5 / M22x1.5 | Puch, Sachs, Beta 521
Width across flats (trigger): 27 mm · Width across flats Screw: 19 mm · Manufacturer: GPO · Clamping depth: 10 mm · Area of application: (Dis)assembly tool · Material: Steel · Surface: blackened · Total length: 55 mm · Total length: 75 mm · Number of components: 1 pcs · Strength class: 8.8 · Thread type: MF22x1.5 (fine pitch thread) · Thread type: MF26x1.5 (fine pitch thread)
EUR 11,20
swiing® ingenious flywheel holder 3 pins (Bosch / Ducati flywheels)
Ø inside: 27 mm · Manufacturer: swiing® ingenious parts · Area of application: Special tool · Material: Steel · Surface: blue galvanized · Surface: rubberized · Diameter: 19 mm · Total length: 290 mm · Height: 80 mm · Ø outside: 93 mm · Thickness: 5 mm · Number of components: 1 pcs · Ø Pin: 8 mm
EUR 54,00
swiing® revival ignition set (Bosch / Ducati / swiing)
Manufacturer: swiing® revival parts · Area of application: Standard · Tension: 6 V · Performance: 17 W · Direction of rotation: left · Direction of rotation: right · Ø mounting plate: 90 mm · Number of fixing points: 3 pcs · Ø cable: 5 mm · Ø Internal flywheel: 90 mm · Alternative version of the Pony Spare part no.: A2656 · Alternative version of Sachs spare part no.: 0283 130 004 · Alternative version of Sachs spare part no.: 0286 254 008
EUR 174,60
Hot 
VEC electronic ignition coil (replaces ignition coil, capacitor & contact breaker)
Manufacturer: VEC · Area of application: Original · Area of application: Performance · Area of application: Standard · Color: black · Ø cable holder: 5 mm · Place of use: Internal (in the ignition) · Total length: 77 mm · Height: 48 mm · Number of fixing points: 2 pcs · Ø mounting hole: 4.6 mm · Mounting type: Screws · Hole spacing: 54 mm · Cable length: 140 mm · Cable length: 420 mm · Ø Internal flywheel: 90 mm
EUR 112,60
Not in stock
GPO / swiing ignition set breaker clockwise 6V
Manufacturer: GPO · Manufacturer: swiing · Material: Aluminum · Tension: 6 V · Performance: 17 W · Direction of rotation: right · Ø mounting plate: 90 mm · Number of fixing points: 4 pcs · Mounting type: Screws · Ø Internal flywheel: 90 mm · Area of application: Original · Area of application: Standard
EUR 225,30
Not in stock
GPO / swiing ignition set, left-hand breaker 6V
Manufacturer: GPO · Manufacturer: swiing · Material: Aluminum · Tension: 6 V · Performance: 17 W · Direction of rotation: left · Ø mounting plate: 90 mm · Number of fixing points: 4 pcs · Mounting type: Screws · Ø Internal flywheel: 90 mm · Area of application: Original · Area of application: Standard
EUR 225,30
Moped fans like you also bought:
Light coil 6V with cable
Area of application: Original · Area of application: Standard · Tension: 6 V · Ø Internal flywheel: 90 mm · Performance: 17 W · Mounting type: Screws · Ø mounting hole: 4.1 mm · Hole spacing: 54 mm · Total length: 76.8 mm · Height: 25.2 mm · Number of fixing points: 2 pcs
EUR 21,30
GPO flywheel 6V / 17W clockwise (Version 2.0) | Puch E50
Manufacturer: GPO · Material: Plastic · Material: Steel · Tension: 6 V · Performance: 17 W · Direction of rotation: right · Thread length: 7 mm · Weight: 900 g · Ø cone small inside: 11.5 mm · Height: 36.5 mm · Ø cone large inside: 15 mm · Cone length: 18.5 mm · Cone ratio: 1:5 · Ø Internal flywheel: 91.1 mm · Ø Flywheel outside: 116.5 mm · Thread type: MF26x1.5 (fine pitch thread)
EUR 99,10
Not in stock
Hot
VEC electronic ignition coil (replaces ignition coil, capacitor & contact breaker)
Manufacturer: VEC · Area of application: Original · Area of application: Performance · Area of application: Standard · Color: black · Ø cable holder: 5 mm · Place of use: Internal (in the ignition) · Total length: 77 mm · Height: 48 mm · Number of fixing points: 2 pcs · Ø mounting hole: 4.6 mm · Mounting type: Screws · Hole spacing: 54 mm · Cable length: 140 mm · Cable length: 420 mm · Ø Internal flywheel: 90 mm
EUR 112,60
Not in stock
Nut M10x1 SW14 Flywheel
Manufacturer: GPO · Area of application: Standard · Material: Steel · Surface: blue galvanized · Nut type: Flange nut · Drive: External hexagon · Height: 8.9 mm · Ø outside: 18.8 mm · Width across flats SW: 14 mm · Thread type: MF10x1 (fine pitch thread) · Pony spare part no.: A4513 · Sachs spare part no.: 0942 072 102
EUR 2,70
Collection only possible with online purchase and appointment.
