Outer circlip which is mounted on the brake anchor plate to fix the brake pads.
This BZ disk is suitable for the front and rear brake anchor plate of Puch Supermaxi mopeds with Grimeca wheel hub.
Details
| Place of use | Brake anchor plate |
| Fuse type | Inside |
| Manufacturer | Puch |
| Nominal diameter | 6 mm |
Suitable for the following models
| Puch |
Moped fans like you also bought:
Magura gas cable clamp / deco cable clamp Ø 5 x 6 mm
Manufacturer: Magura · Material: Brass · Material: Steel · Surface: nickel-plated · Ø outside: 5 mm · Number of components: 2 pcs · Total length: 6 mm · Ø Cable bushing: 1.6 mm · Drive: Slot · Screw head: Lens head · Thread type: M4x0.7 (standard thread) · Thread length: 4 mm
EUR 2,35
NTN wheel bearing 12/28/8 rear cast hub Leleu | Puch Maxi
Bearing type: Deep groove ball bearing · Stock number: 6001 · Inner ring width: 12 mm · Manufacturer: NTN · Ball bearing closed: Yes · Dust protection type: 2RS - NBR contact seal on both sides · Bearing clearance: CM (special/noise-reduced) · Bearing cage: "-" Sheet steel cage ball-guided · Groove ring: No · Material: Plastic · Material: Steel · Surface: blank · Width: 8 mm · Ø outside: 28 mm · Ø inside: 12 mm · Area of application: Standard
EUR 6,90
swiing® revival wheel axle set M12x1 x 185 cast rear wheel galvanized | Puch
Manufacturer: swiing® revival parts · Material: Steel · Surface: galvanized (blue) · Ø outside: 11.8 mm · Width across flats SW: 19 mm · Total length: 185 mm · Shank length: 100 mm · Ø shaft: 11.9 mm · Thread type: MF12x1 (fine pitch thread) · Thread length: 26 mm · Thread length: 52.5 mm
EUR 17,40
Collection only possible with online purchase and appointment.
